![]() The scrollwheel may be used to control the field of view. Holding the middle button down while moving the mouse shifts the viewpoint. Clicking the left mouse button resets the view direction. FlightGear Autopilot GUI from publication: DESIGN OF AN EFFICIENT & WEATHER RESISTANT FLIGHT PATH MODULE FOR GUIDANCE OF A. ![]() QGroundControl should be able to automatically connect to the simulated vehicle. The commands above launch a single vehicle with the full UI. In view mode (arrow cursor), you can control the view direction using the mouse. cd /path/to/PX4-Autopilot make px4sitlnolockstep flightgearrascal The supported vehicles and make commands are listed below (click on the links to see the vehicle images). Using auto-coordination (-enable-auto-coordination) is recommended. however, judicious use of > filters and variable gains can usually get you around most > problems. Holding the left mouse button down allows control of the rudder (left/right), while holding the middle mouse button controls throttle (forwards/backwards). Setting up Piccolo autopilot configuration (control surfaces, tail configuration. Moving the mouse controls the aileron (left/right) and elevator (forwards/backwards). Setup for the FlightGear-flight-simulator-based SITL. In control mode (cross hair cursor), the mouse is used to directly control the aircraft in the absence of a joystick. Press Ctrl-c to view panel/cockpit hotspots. The scrollwheel may be used on some controls. An autopilot ( AP) is a mechanical, electrical, or hydraulic system used to guide a vehicle without assistance from a human being. The left mouse button makes small changes while the middle button makes larger ones. The autopilot setting dialog of FlightGear. The original FlightGear FDM was LaRCsim, originally modeling only a Navion. Generally, the left side of the control decreases the setting, while the right side increases the setting. Other simulator components, such as the autopilot, are designed to expect a. To change a control, click with the left/middle mouse button on the corresponding knob/lever. In normal mode (pointer cursor), the panel and cockpit controls can be operated using the mouse. There are three mouse modes, which can be swapped between by pressing the TAB key, since FlightGear version 3.0, or by clicking the right mouse button for previous versions.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |